Shock Extension - 18+ Softail

If you are looking to lift the back end of your 2018 and up Softail model without the big cost of a new shock, then this is for you.  The shock extension is a replacement eyelet that installs on the swing-arm side of the shock.  It is made of aluminum with sealed, double row needle bearings, already pressed in place.  Installing this longer eyelet will give you approx 1-3/4" of lift at the rear axle.  Because the factory spring is unaffected, as well as shock angle which keeps your stock spring rate and valving the same as factory.  Makes for greater ground clearance, as well as making it easier to get that front tire off the ground.  Requires removal of shock and compressing the spring to install.

• Made of aluminum
• Needle Bearing, Pre-installed
• For 2018 and up Softail models
• Sold Each 

We ship worldwide, and from a large number of supplier.

For EU stock, we usually receive your pieces under 48 hours, and ship it to you the same day. The delivery time depend of your location.

For US stock, it take 3 to 4 weeks to get your article, then the usual delivery time, depending once again of your location.

Some pieces of certain supplier can take a lot of time, as they are crafted on demand.

To avoid any difficulty, we would advise you to contact us regarding your potential order, and we will give you a clear and specific statement of the delivery time.

+33 09 78 80 63 99

info@holydeathshop.com