DD7 - Direct Drive 7-Speed Gearboxe

The DD7 upgrades any existing 2006-later big twin 6 speed to a full 7 speed transmission.  The BAKER DD7 is more than just another gear added to the mix for the sake of one-upmanship. That 7th gear enables the motorcycle to now make full use, by way of gear ratio management, of the torque and power put out by the new 96 CI and 110 CI motors rolling off the assembly line in Milwaukee. We did not make this transmission a deep overdrive, rather we shortened 1st gear and tightened up the gears to deliver the riding experience that you were after when you bought your bike. The gear ratios leave you the rider, with the experience of smooth, crisp, continuously pulling acceleration from 1st all the way through 4th gear. Then you are able to start getting into the cruising portion of the program in gears 5th-7th. No big drops in RPM from one gear to the next or lugging the motorcycle off of a stop light, just smooth, uninhibited acceleration.

We did not stop at just fixing the gear ratios. We improved the smoothness and crispness of the shifting by reducing the mainshaft mass by only having 1st gear be a part of the shaft, rather than 1st-4th gears like on the stock unit. Reduction in rotating mass for shift quality is a fact that has been utilized in the automotive world for years. We ditched the stock detent arm and spring assembly from the door in favor of a Linear Detent that decreased friction while increasing smoothness when coupled with the all new shift drum design. We have tightened up the dog teeth on the gears to prevent the loud clacking noise that accompanies every shift on the factory 6 speed. Through the use of a billet bearing door, 28% wider bearings in the door, steel bearing retainer plates and full width gears, the durability and strength of our unit is a drastic improvement. By utilizing fully diamond ground, helical gears in 1st & 4th-7th we are able to deliver a much quieter riding experience. While 2nd and 3rd gears are diamond ground, spur gears to handle the peak torque that is reached in that range.

NOTE: To upgrade your older DD7 to the new Tapered Bearing style main drive gear bearing you must purchase PN 740-67. The current kit comes standard with the Tapered Bearing Kit.

We ship worldwide, and from a large number of supplier.

For EU stock, we usually receive your pieces under 48 hours, and ship it to you the same day. The delivery time depend of your location.

For US stock, it take 3 to 4 weeks to get your article, then the usual delivery time, depending once again of your location.

Some pieces of certain supplier can take a lot of time, as they are crafted on demand.

To avoid any difficulty, we would advise you to contact us regarding your potential order, and we will give you a clear and specific statement of the delivery time.

+33 09 78 80 63 99

info@holydeathshop.com